PowerTek PowerBeam ACD039 - AC Charging; DC Charging; Specifications

Model No. ACD039
A. AC Charging At Home with 110 Volt Charger
1. KeepthePowerSwitchinmiddle“O”offpositionwhilecharging.
2. Insert the AC charger round plug into the Spotlight Charging Port  located at the back of the
 spotlight.
3. Connectthe110VoltACChargerintothe110VoltAChomereceptacle.
4. Fullychargethespotlightaccordingtothefollowingchargingschedule:
 Firsttimecharge:.....................................................24hours
 Rechargeandsubsequentcharge:.......................18hours
5. Unplug the AC charger from the 110 Volt receptacle rst and then remove theround plug
 fromtheSpotlightChargingPort.
B. DC Charging In Your Vehicle with 12 Volt Charger
1. KeepthePowerSwitchinmiddle“O”offpositionwhilecharging.
2. Insertthe12VoltDCChargerroundPlugintotheSpotlight
3. ChargingPortlocatedatthebackofthespotlight.
4. Connectthe12VoltDCChargerPlugintothevehiclecigarettelighteror12Voltaccessoryport.
5. FullychargetheSpotlightinternalbatteryfor8hourswhilethevehicleengineisrunning.
6. UnplugtheDCchargerfromthevehiclecigarettelighteror12Voltaccessoryportrstandthenremovethe
 roundplugfromtheSpotlightChargingPort.
12 VOLT DC CHARGER ADAPTOR FUSE REPLACEMENT:
1. Unscrewtheretainerringatthetipofthe12VoltDCchargerplug.
2. Replacetheinternalglassfusewiththesamegradefuseratedat2-AMP.
SPECIFICATIONS:
600Peakcrankingamps 300continuouscrankingamps
Batteryratedcapacity 12Volt-8Ah
Bulb H4-120WattQuartzHalogenBulb
LEDarealight 360mA
Sheet 7 of 8