EasyManua.ls Logo

PowerTek PowerBeam ACD039 - Positive Grounded System; Charging Instructions

PowerTek PowerBeam ACD039
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Model No. ACD039
Positive Grounded System:
ConnecttheBLACKCLAMP(negative-)tothenegativeterminalofthevehiclebattery.
ConnecttheREDCLAMP(positive+)tothevehicleengineblock,orametalpartofthevehiclewhich
isconnectedtothevehiclegroundsystem.Donotclampdirectlytopositivebatteryterminal,mainfuel
distributionmoduleorsheetmetalparts.
ThePolarityProtectionSystemGREENLEDisilluminatediftheproperconnectionshavebeenmade.
WARNING: If RED LED is illuminated, STOP and disconnect the booster clamps from battery
terminals. Reconnect the booster clamps by reversing the connections to the proper battery
polarity.
1. TurnontheMainPowerBoosterClampsSwitchbyrotatingtheswitchtotheONposition.
2. Allow3to5minutesofchargetime.Itishighlyrecommendedhavingasecondpersontoassist
holdingtheunitsecurelyinplaceduringthenextsteps.
3. StarttheengineandStopifthevehicledoesnotstartafter2to3secondsofenginecranking.Wait
2to3minutesthentryagain.Repeattheabovestepsseveraltimesuntilthevehiclestarts.
4. Ifthevehiclestarts,turnofftheMainPowerSwitchbyturningtheswitchtotheOFFposition.
5. Disconnecttheclampsasfarawayfromthevehiclebatteryaspossible.
6. ForNegativeGroundedSystem,disconnecttheBLACKCLAMPNegativerstandthentheRED
CLAMPPositive.ForPositiveGroundedSystem,disconnecttheREDCLAMPPositiverst,and
thentheBLACKCLAMPNegative.
7. Stowtheboosterclampsintotheirstoragecompartment.
CHARGING INSTRUCTIONS:
USE CAUTION:
Priortochargingthisdevicereadalltherelatedinstructionsindicatedbelow.Thisproductmayarrive
partiallychargedfromthefactory.Itishighlyrecommendedtofullychargetheunitafterpurchaseand
beforeinitialuse:
• MakecertainthatthePowerSwitchissettotheoffposition.
• Do not charge near ammable material, open ames or any location which may accumulate
ammablefumes.
• Makecertainthatanyelectricaloutletusedtochargethisdevicethatislocatedinapotentiallywet
ormoistareaisprotectedbyaGroundFaultCircuitInterrupter(GFCI).
• Makesurethatbothboosterclampsaresecurelyplacedintheirdesignatedstoragecompartments
whennotinuseandduringthechargingperiod.
Sheet6of8