Why is my Powrtran Fishing Equipment wireless remote not working?
If your Powrtran Fishing Equipment wireless remote isn't working, the first thing to check is the remote battery. A dead battery is a common cause. Replacing the remote battery should solve the problem.
Why does my Powrtran Tailfin Fishing Equipment system turn more one way than the other?
If your Powrtran Fishing Equipment system only turns more one way than the other, it might be due to an incorrectly set actuator. To fix this, follow steps 20-26 to properly set the actuator center and/or non-turning point. Then, install the lock-to-lock linkage.
What to do if Powrtran Fishing Equipment system turns more one way than the other?
If your Powrtran Fishing Equipment system only turns more one way than the other, the linkage mounting point might be incorrect. Adjust or reinstall the linkage mounting point, ensuring it's as close to the center of the outboard as possible.
Why does my Powrtran Tailfin system make a grinding noise?
If your Powrtran Fishing Equipment system is making a grinding noise, the actuator might not be properly lubricated. Remove and re-grease the actuator to resolve this issue.
What to do if Powrtran Tailfin system only turns one direction?
If your Powrtran Fishing Equipment system only turns in one direction or doesn't turn at all, remove and reinstall the motor, making sure the shafts remain engaged.
What to do if Powrtran Tailfin wireless remote is not working?
If your Powrtran Fishing Equipment wireless remote is not working, there are a couple of things to check. First, the remote battery may be dead, so try replacing it. If that doesn't solve the issue, the remote might not be synced with the system. Refer to page 36 for instructions on how to sync the remote with the system.
Why does my Powrtran Fishing Equipment system only turn one motor and actuator?
If your Powrtran Fishing Equipment system only turns one motor and actuator, it could be caused by shafts not being fully engaged. Remove and reinstall the motor, making sure the shafts remain engaged. Another possible cause is stress on the linkage. Make sure the linkage arm is parallel to the actuator.
How to fix a grinding noise in my Powrtran Fishing Equipment system?
If your Powrtran Fishing Equipment system is making a grinding noise, it's possible that the actuator is not properly lubricated. You should remove and re-grease the actuator. See page 39 for instructions.
Details on assembling linkage arms based on kit and orientation.
Instructions on how to pair the controller and remote.
Steps to adjust the system's acceleration rate.
Instructions for adjusting the motor speed settings.
Procedure to reverse the motor's directional control.
Procedure to restore the system to its original factory settings.
Guidelines for protecting the system from moisture, gasses, and salt.
Instructions for disassembling, cleaning, and re-greasing the actuator.
Table of LED blink patterns indicating system faults.
General| Brand | Powrtran |
|---|---|
| Model | Tailfin |
| Category | Fishing Equipment |
| Language | English |
To Next Page