User Manual
ScanLog 96 Pen Drive Version
11
USB Port Failure
In case of any failure of the USB port itself; one of the following two messages may be displayed on the front panel LCD
depending upon the type of error. The ScanLog needs servicing for any further Pen Drive operations.
If no error is encountered while opening/creating a file for copying the records, the ScanLog
begins downloading the records with the message shown in the figure 3.4(a). The upper row
shows the operation type; Copying for ‘Copy’ operation or Re-copying for ‘Re-copy’ or ‘Recover’
operation. The Lower Row displays countdown of the numbers of balance records.
Upon successful completion of the operation, the ScanLog displays the total numbers of records
copied (or, re-copied) through the message shown in figure 3.4(b). Remove the Pen Drive and
acknowledge the message using ENTER key. The ScanLog reverts to normal RUN mode.
‘Read Set.txt File’ Operation
Upon selecting ‘Read Set.txt File’ operation, the ScanLog opens the file named Set.txt for reading the user defined Instrument
Name, File Name & Channel Names (refer section “File System for Read Operation”).
If there is an error in opening the file or any other errors encountered while reading the file; the ScanLog displays an
appropriate error message on the Upper Row.
For various error messages and their meaning, refer Table 3.2 below.
Table : 3.2
In case of any of the above Error Messages, make sure that the Pen Drive is firmly inserted in the
USB port and retry the operation by acknowledging the error message through front panel
ENTER key. If the error persists, replace the Pen Drive.
If no error is encountered while opening, reading or closing the file, the ScanLog displays the
message shown in figure 3.5 after successfully reading file contents. Remove the Pen Drive and
acknowledge the message using ENTER key. The ScanLog reverts to normal RUN mode.
Error Message
What it Means
Unable to open the Set.txt file or read the file size.
Unable to read the file contents.
Unable to close the file after successful reading file contents.
Cant Sync USB Cant Change Baud
Cant Open File
Cant Close File
Cant Read File
Figure : 3.5
Names Assigned
Figure : 3.4(a)
Copying.....
Bal 1234
Figure : 3.4(b)
Records Copied
1234
To Next Page
Loading...