PPI ScanLog 96 - Alarms Parameters

User Manual
ScanLog 96 Pen Drive Version
14
Parameter Description
SELECT CHANNEL
(Available only for Dual Channel Version)
Select the desired Channel Name whose Alarms parameters are
to be set.
1 or 2
Settings
(Default Value)
ALARM SETTINGS
Section 5
The Figure 5.1 shows how to access Alarm Setting Parameters. The Example illustrates how to change the Alarm 2 setpoint
value for channel 2.
Figure 5.1
Main Screen
First Page
Next (desired)
Page
Press SET-UP Key
or
First Alarm (AL1)
*Desired Channel
Press UP/DOWN Keys
to select Channel Value
Press ENTER Key
to select Alarm
number
or
Press UP/DOWN Keys
to select next Page
Press ENTER Key
To open Alarm
Settings List
or
Press UP/DOWN Keys
to select Alarm Number
Desired Alarm
Number
Press ENTER Key
to open AL2
Parameter List
Press ENTER Key
to select desired
parameter
or
Press UP/DOWN Keys
to adjust Parameter Value
Press ENTER Key
to store the New Value
& to move to Next Parameter
*First Parameter
in Alarm Settings
List
First Parameter
for Alarm 2
Desired Parameter
for Alarm 2
Desired Value Next Parameter
Boiler Pressure
2.1 PSI
SELECT PAGE>>
Operator Paras
SELECT PAGE>>
Alarm Settings
SELECT CHANNEL>>
1
SELECT CHANNEL>>
2
SELECT ALARM>>
AL1
SELECT ALARM>>
AL2
AL2 TYPE>>
Process Low
AL2 SETPOINT>>
1.6
AL2 SETPOINT>>
1.4
AL2 HYSTERESIS>>
0.2
* Parameters not present in Single Channel Version