2 3000V101-UK
SYMBOL IDENTIFICATION
Triangle with an exclamation mark: Read the manual before
installation and commissioning of the device in order to avoid
incidents that could lead to personal injury or mechanical damage.
The CE mark proves the compliance of the device with the
essential requirements of the directives.
Ex devices have been approved according to the ATEX directive for
use in connection with installations in explosive areas.
WARNING
To avoid the risk of electric shock and fire, the safety instructions
of this guide must be observed and the guidelines followed. The
specifications must not be exceeded, and the device must only be
applied as described in the following. Prior to the commissioning
of the device, this installation guide must be examined carefully.
Only qualified personnel (technicians) should install this device.
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired. Until the device is fixed, do not connect hazardous
voltages to the device.
Repair of the device must be done by PR electronics A/S only.
In applications where hazardous voltage is connected to in-/
outputs of the device, sufficient spacing or isolation from wires,
terminals and enclosure - to surroundings (incl. neighbouring
devices), must be ensured to maintain protection against electric
shock.
Potential electrostatic charging hazard. To avoid the risk of
explosion due to electrostatic charging of the enclosure, do not
handle the units unless the area is known to be safe, or appropriate
safety measures are taken to avoid electrostatic discharge.
GENERAL
HAZARD-
OUS
VOLTAGE
CAUTION
To Next Page
Loading...
Need help?
General
