5/34
3. APPEARANCE
The projector’s Structure
1. Front Lens
2. Lens Cover
3. Head Cover
4. Tilt Lock
5. Handle
6. Pan Lock
7. Arm Cover
While transportation, the head should be locked-Tilt Lock(4) and Pan Lock(6) should be at locking positions.
Before the use of the projector, unlock both.
Rear Panel of the Base
1. Power Switch
2. Fuse Holder
3. Power Socket
4. 3-Pin XLR Socket(Male)
5. Wireless Antenna
6. 3-Pin XLR Socket(Female)
7. 5-Pin XLR Socket(Male)
8. 5-Pin XLR Socket(Female)
Front Panel of the Base
1. XLR Signal Indication
2. Key Func
3. Key UP
4. Key Down
5. Key Enter
6. Wireless Signal Indication
4. INSTALLATION
●
RIGGING
Before moving a projector, Please lock Pan and Tilt. Before its operation, please unlock them. It’s forbidden to run a
projector with power while it is locked
To Next Page
Loading...