praher SUPERSTAR E-3000/F2

To Next Page

3 G

4 C

7 - 8

Page

Safety references

eneral regulations / Intended use

Assembly

ycle sequence/rinsing times

Digital clock/Prog. Back rinsing trigger time

Function film keyboard

Settings for back and clear rinsing duration

Setting for deceleration time

Electr. Connection

Board for E-3000/F2 - 24V

Exploded view

Operating instructions

SUPERSTAR E-3000 / F2

for 1 1/2", 2"and 3" 24 VAC

Table of contents:

Ensuing damage due to neglect of the operating instructions or due to damaging sealed parts lead to a lapse

of the warranty. We do not take on liability for thus resulting damages! Please read the operating instructions

carefully before starting.

PRECISION - POWER - PROGRESS - PRODUCTION

Main Page

Need help?

Do you have a question about the praher SUPERSTAR E-3000/F2 and is the answer not in the manual?

Summary

I. Safety Instructions

2. General Product Information

3. Intended Use

4. Assembly and Installation

5. Cycle Sequence Operation

7. Digital Clock Adjustment

8. Back Rinsing Program Setup

9. Key Function Controls

10. Duration Adjustments

10.1 Clear Rinsing Duration

Guides on adjusting the duration for the clear rinsing phase.

10.2 Deceleration Time Adjustment

Instructions for setting the deceleration time for operational pauses.

11. Electrical Connections Overview

a) Supply Voltage & Dry Operation

Covers supply voltage (24 VAC) and dry operation protection via float switch.

b) Pump & Ball Valve Connections

Details connections for the pump and the ball valve.

c) Back Rinse Pump & Signal Connections

Explains connections for the second back rinse pump and signal outputs.

g) Heating;Heat Exchanger Signal

h) Serial Connection Signal

i) External Trigger Inputs

j) Technical Data

Circuit Diagram (E-Type)

Connection Plan (MIL 72 E Clock)

Exploded View and Parts List