The generators that do not belong to the category
described previously are constructed in compliance
with the technical standards harmonised with the EU
Directive 2006/42/EC, however, they are not
accompanied by the CE Declaration of Conformity;
in this case, the identification plate does not bear the
“CE” symbol (see the "identification of the
generator” paragraph).
2.3 CE Declaration of
Conformity
The CE Declaration of Conformity is attached to this
instruction manual
2.4 Description of the
generator
The paragraph identifies the main components of
the generator, which are normally supplied as
standard. Additional components, called "extras” can
be installed.
The generator is supplied with different diesel
engines and rated power outputs based on the
specific model.
Another difference is the possibility of choosing
between the OPEN SET and the SOUNDPROOF
model. The OPEN SET model is made up of a
bearing base upon which the main components are
mounted (engine, alternator, control panel, etc.).
The SOUNDPROOF generator, built with the same
criteria as OPEN SET, is equipped with soundproof
panels which completely enclose all the main
components mounted on the base.
OPEN SET
SOUNDPROOF
NOTE
Both models must be installed by
trained and qualified personnel. In
particular, OPEN SET models
installed within the European
Community must be positioned in a
safe place, which is only accessible
to trained and qualified personnel
and sufficiently sheltered against the
direct action of atmospheric agents.
# Component
1 Base
2 Engine
3 Silencer
4 Air filter
5 Radiator
6 Control panel
7 Utilities connection
8 Alternator
9 Soundproof panels
10 Doors
To Next Page
Loading...
