7 Operation
Off / Run / Choke switch
The Off / Run / Choke switch controls the flow of gasoline from the fuel tank to
the carburetor. The switch should be in the “I” position when starting and
operating the generator. The switch should be in the “O” position when the
engine is not running and when storing or transporting the unit.
NOTE: The Off / Run / Choke switch helps to prevent stale fuel from remaining in
the carburetor while storing or transporting the unit. Run the fuel out by turning the
knob to the “O” position and letting the engine run until it stops.
Choke
The Choke position on Off / Run / Choke switch is used when starting the engine
“cold” (the engine is not hot).
NOTE: Choke is not required to start a warm engine.
One-key start switch (where avaiable)
When the combination switch is placed in the “On” position, operate the start
switch button to start the engine.
To Next Page
Loading...
