Need help?Do you have a question about the Precisa 300 S series and is the answer not in the manual?
General| Category | Scales |
|---|---|
| Brand | Precisa |
| Interface | RS232 |
| Calibration | External |
| Series | 300 S series |
Explains how weight is measured and regulated via a feedback loop.
Describes how coil current is converted and processed electronically.
Explains the measurement principle and control loop.
Describes the electronic evaluation of the measurement current.
Step-by-step instructions for safely opening the balance.
Steps to change the mains voltage setting on the 300S model.
Guide for installing the remote display cable for freestanding units.
Guide for mounting the remote display onto the balance.
Instructions for installing the 20mA current loop data output.
Guide for installing the external T-key connecting cable.
Instructions for connecting IEC 625/IEEE 488 data output interfaces.
Instructions for exchanging the main board.
General guide for disassembling and assembling the balance.
Guide for disassembling and assembling the 300 SCS balance.
Steps for calibrating the balance.
Procedure for adjusting corner load balance.
Steps to perform linearisation of the balance.
Calibrating the internal reference weight on 300 SCS.
Calibrating internal reference weight for gauged balances.
Procedure for correcting S-curve deviations.
Detailed steps for performing the S-correction.
Procedure for compensating for balance drift.
Lists common errors and their causes during operation.
Errors occurring during normal operation and their remedies.
To Next Page
