7
11 10mm thick steel rear gap plate. Part of Mmag dual gap
motor assembly.
12 10mm thick steel rear plat / pole piece T yoke Part of Mmag
dual gap motor assembly.
13 1 inch flared Vent. Part of enhanced voice coil cooling system
(forced convection).
14 Two stack ceramic magnet for rear gap Part of Mmag dual
gap motor assembly. Total magnet weight of items 10 & 14 is
155 oz.
15 High temperature (Polyester Amide Amide Resin Coated)
Copper dual voice coil (2x4 ohm) wound on an).
16 Voice coil heat pick-up and heat sink assembly that also
serves as a control for flux and heat build up and control
in the dual gap motor. Part of enhanced voice coil cooling
system (forced convection – aluminum heat sinking –shorting
rings to reduce inductive heating).
17 Aluminum voice coil former (voice coil is a 3”).
18 Vented spider ring and terminal block assembly. Integrates
custom terminals and impedance jumper block. Venting in
spider ring is part of enhanced voice coil cooling system
(forced convection).
19 Vent holes in flat panel yoke assembly. Part of enhanced
voice coil cooling system (forced convection – aluminum heat
sinking –shorting rings to reduce inductive heating).
To Next Page
Loading...