11
15. Secure the bag corners around the Lower Hopper Side Tubes by snapping the Bag Flaps to the Bag
Bottom on both sides. See Figure 15.
IMPORTANT: Do not over bend the Support Rods during the following step. Over bending will cause the
steel rods to lose supporting tension.
16. Tip the Hopper onto it’s back to assemble the two Hopper Support Rods. Place the ends of each rod into
the Upper and Lower Rear Hopper Tubes, bending the rod just enough to fit into the holes of the tubes.
See Figure 16.
Snap
Flap
Figure 15
Figure 16
Lower Rear
Hopper Tube
Upper Rear
Hopper Tube
Support Rod Support Rod
To Next Page
Loading...