Rev 8/2014
PrecisionTemp, Inc • 11 Sunnybrook Drive • Cincinnati, Ohio, 45237 • 1-800-934-9690 •
fax 513-641-0733 7
PrecisionTemp will cover warranty work preformed only on PrecisionTemp
products for defects in material or workmanship, not problems related to the
facility, installation or related equipment issues such as:
• Improper water pressure.
• Tripped circuit breaker.
• Improper installation including blocked access to heater access panel.
• Improper primary hot water temperature or water pressure issue.
• Cold water bypass or negative air pressure in facility.
• Improper power hookup or power turned off.
• Undersized gas line or low gas pressure.
• Water flow problems caused by the ware washer such as liming or
defective solenoid valves.
• Excessively long recirculation loops or undersized plumbing components.
• Any problem that is a result of any of the above situations that occur due
to misrepresentation of the facilities to PrecisionTemp, consultants or
installers prior to or after equipment installation.
Warranty coverage is based on PrecisionTemp’s warranty policy.
PrecisionTemp may, at times, arrange service as a courtesy to the
customer. This does not imply that PrecisionTemp guarantees the
performance of this service or is responsible for the charges.
PrecisionTemp will not pay for additional time required to gain access to its
equipment or for the technician not being given access to equipment in a
reasonable time-frame. PrecisionTemp reserves the right to accept or deny
warranty claims based on the above policy.
To Next Page
Loading...