page 16
COMMERCIAL PRODUCTS DIVISION
Important:
With the handrails attached, the width of the treadmill is 33½
inches (85 cm). It will not fit through a standard 32-inch doorway.
11. Attach the handrails. Diagram 13. For ease of assembly, place the side rails
or adjustable rear feet on blocks. Obtain assistance to lift the treadmill. Do
not place blocks beneath the running bed.
To attach the handrails, perform the following steps on
one side at a time
:
a. Alignment pins on the top of the handrails necessitate sliding the handrails
into the console assembly at a 45
ο
angle. Position the handrail as shown in
Diagram 13, #1 and #2 and slide it onto the console extension. When the
alignment pins are fully engaged, carefully lower the handrail toward the
base. Insert two flat head screws (C) into the upper handrail mounts and
finger-tighten. See Diagram 13, #3.
b. Align the lower handrail bracket with the two base mounts and insert two
screws (A) with washers (B). See Diagram 13, #4. Tighten the screws with
the hex key. See Diagram 13, #5.
c. Return to the upper handrail screws and securely tighten each one.
d. Perform steps a. through c. on the opposite side.
e. Obtain assistance and remove the blocks from beneath the base.
Diagram 13
Handrail alignment and installation.
3
2
Console
extension
1
45
ο
angle
4
5
Handrail
Screw (A)
and
washer (C)
Lower
handrail
bracket
To Next Page
Loading...
Need help?
General
