Assembling the EFX 19
9. Attach the cable to the appropriate connector inside the
base of the EFX, as shown in the following illustration and
table.
Figure 6: Cable connection points inside EFX base
Connect … To …
The console power cable (red
and black, individual leads)
The power connector on the jack
panel
The television cable (black and
round)
The coaxial connector on the
jack panel
The Ethernet cable (black and
flat)
The eight-connector modular
jack on the jack panel
10. Repeat steps 7 through 9 for the remaining cables you
want to install.
11. Replace the central plastic base cover, then attach the
four buttonhead screws you removed along with the
cover. Tighten the screws completely.
To Next Page
Loading...
