EasyManua.ls Logo

Predator 35 - Installation; Unit Assembly and Placement; Initial Setup and Water Filling; Remote Control Setup

Predator 35
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
INSTALLATION
1. Assemble the casters (g.1).
2. Place the unit on a at and stable surface.
3. Before using it for the rst time, ll the water tank and place it properly.
4. Plug on the air cooler. (g. 2, g. 3).
5. Remote Control:
Before using the remote control for the rst time, insert the battery as shown in the
picture. (g 4).
When replacing the battery, be sure to buy one of the same type (CR 2023)
The reception distance of the remote control is about 3 to 6 meters and its central an-
gle is 30 to 45 degrees. If the remote control does not work in a short distance, replace
the battery. Keep the remote control in a safe place carefully. Do not let children use it
as a toy.
If the remote control is not going to be used for a long time, remove the bat-
tery to avoid deterioration.
CR 2023
(Figure 1)
UPWARD
(Figure 3)
(Figure 2)
(Figure 4)
(Install the battery in the remote control)

Related product manuals