Page 14 For technical questions, please call 1-888-866-5797. ITEM 58169
SAFETY SETUP OPERATION MAINTENANCE
5. Allow the Engine to run for 10 –15 seconds with
the Choke in the START position. Then pull up
on the Throttle Control Lever to automatically
move the Choke lever to its RUN (open)
position. Release the Throttle Lever.
IMPORTANT: Allow the Engine to to warm
up at idle for 2–3 minutes after each start-up
so that the Engine can stabilize.
WARNING! TO PREVENT SERIOUS INJURY:
If the Tines rotate with the Engine idling and the
Throttle Control Lever fully released, turn the Idle
Adjustment Screw counterclockwise to decrease
idle speed until the Tines stop rotating.
To Restart a Warm Engine
Leave the Choke in Run position. If Choke is not in Run position pull and release the Throttle
Control Lever to return Choke to its RUN position and follow Steps 3 and 4 in the starting
instructions above. If Engine fails to start use the cold engine starting procedure.
Stopping the Engine
1. To stop the engine in an emergency,
release the Throttle Control Lever and
turn the Engine Switch OFF.
2. Under normal conditions, use the following procedure:
a. Release the Throttle Control Lever.
b. Let Engine idle for 1 – 2 minutes.
c. Turn the Engine Switch OFF.
d. Clean external parts with clean cloth, remove debris from Tine Blades and Shaft, then cover the
equipment and store in a dry, level, well-ventilated area out of reach of children. Under normal operating
conditions subsequent maintenance follows the schedule explained in the MAINTENANCE section.
NOTICE
See Long-Term Storage on page 19 for complete storage instructions.
Pull
Throttle
Lever Up
Choke
in Run
position
Idle
Adjustment
Screw
5
Turn Switch OFF
Release
Throttle
Lever
To Next Page
Loading...
