Read all these instructions carefully before first use and keep for future reference.
Remove all packaging materials and dispose of responsibly.
Before turning on the Cupcake Maker. Clean the cooking plates by wiping with a
damp sponge or cloth.
DO NOT IMMERSE THE APPLIANCE UNDER WATER OR RUN THE
APPLIANCE UNDER A FAUCET TO CLEAN.
Dry the cooking plates with a soft dry towel or cloth.
For best results before adding any mixture into the moulds always spray the
cooking plates with a light cooking oil, this will help the cupcake to release cleanly
from the moulds.
NOTICE: When the Cupcake Maker is switched on for the first time it may
emit an odour. This is normal for the appliance and does not affect the safety
of the appliance.
In a closed state plug the power cord of the Cupcake Maker into a 120V power outlet.
The power light will illuminate on the top of the Cupcake Maker indicating that it is
heating up.
After approx. 5 minutes the power light will switch off indicating that the Cupcake
Maker has reached the optimum temperature to start baking your cupcakes.
Disengage the handle lock and open the Cupcake Maker by its handle. Into the base
cooking plate ladle in the cupcake mix of your choice and fill the moulds on the base
plate leaving around ¼” space to the top of the mould.
Carefully close the top lid down onto the base and engage the locking handle. In this
closed state the power light will illuminate again to indicate that the cupcakes are
starting to bake.
2
To Next Page
Loading...