PRESSUREPRO DESCRIPTION
PressurePro is a wireless electronic Tire Pressure Monitoring System (TPMS) that is
designed to display current tire pressures on demand, whether moving or stationary.
PressurePro systems, which can be used on all pneumatic tires, consists of two basic
components: Tire Sensors which screw onto the valve stems of the tires, and a Display.
The Sensors read tire pressure every 7 seconds (12,343 times a day), and transmit a
coded RF signal to the Display every 5 minutes assuring timely information. If an
alarm level is reached, PressurePro Sensors will override the normal update and alert
the Display immediately (see “Alerts” section). During an alert, the tire location
flashes on the Display, the current pressure reading for that tire flashes, and an
audible alert sounds.
PressurePro systems provides users with the market’s most comprehensive alert
schedule, with two low pressure alerts, a high pressure alert, a high temperature
alert, a fast leak alert, and a cross axle alert, all user customizable.
PressurePro is a monitoring system and will not prevent tires from losing pressure or
failing, but it can provide early notice of potential problems and alert to low tire
pressure situations. Because of the quirks of RF Transmissions and interference, no
guarantee of signal reception can be made. PressurePro is not meant to function as a
pressure gauge or low pressure indicator.
2
Regulatory Information
PressurePro Tire Sensors
FCC ID: RMDAPS2 Model: APS2
IC: 4785A-APS2
PressurePro Pulse Display
Contains FCC ID: RMD4R Model: APM4
Contains IC: 4785A-4R
These devices comply with Part 15 of the FCC Rules and with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Les présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Conformity documentation is held on file at PressurePro’s Headquarters. Copies can be
obtained by authorized parties by calling +1-816-887-3505, or by submitting an inquiry
to support@pressurepro.us.
15
To Next Page
Loading...