TRANSMITTER PROGRAMMING GUIDE
Model : APS 95 BT3
The transmitters included with the security system have been pre - programmed
at the factory, with each button pre - assigned to control a specific function of the
security system. Although the security system in the vehicle has either 3 or 4
channels ( RECEIVER ) depending on the model, the transmitters included with the
system are 7 channel transmitters. This allows you to program each transmitter to
more than one vehicle in two car families, and also allows you to change which button
( s ) control certain functions of the system. ( Example: Transmitter channel 5
can be programmed to activate Receiver channel 2. ) Refer to the chart below
for access to each of the transmitter channels, and for the standard factory
button assignments.
TRANSMITTER SYSTEM RECEIVER
CHANNEL BUTTONS CHANNEL FUNCTION
1 1 1 Remote Arm & Disarm
Remote Emergency Panic
Remote Door Lock & Unlock
2 2 2 * Pulsed Output for Accessories
3 3 3 * Switched Output for Accessories
4 2 & 3 4 * Switched Output for Accessories
51 & 2- -
61 & 3- -
7 1, 2, 3 - -
* Some of the more common accessories for these additional channels are;
AS 9151N Remote car starter
AS 9153 Remote window roll up
AS 9256 Remote trunk release relay
128-4619
1 of 12
Released (ENGLISH ONLY) 8-15-95.
Released French & Spanish. 10-31-95.
To Next Page
Need help?
General
