general
Remove
811
parts and check
to
be
sure
they are
there. Report to your dealer if any parts
are
missing
or
damaged.
One Carton Containing
Fireplace and Spark Strips.
ALSO
Any other cartons you have ordered to complete
your chimney installation.
NOTE:
Ta
identify pieces, refer
to
Parts Illustration.
Local Codes
Local
building codes should be consulted in all cases
as
to
the particular requirements concerned with the
installation of factory built fireplaces,
DO NOT INSTALL IN MOBILE HOME
IMPORTANT
The fireplace may be installed either with the
area above the fireplace open within the en-
closed framing (chase framing) or inset from the
sides of the fireplace. When insetting is desired
the chimney spacer MUST be installed (See Fig. 6).
For your safety and protection, fireplace and
chimney should be grounded. Use Ground Rod,
clamp and wire to ground chimney and fireplace.
MUST
TERMINA
36” MINIMUM
ABOVE ROOF
FIREPLACE
OPENIN<
FLOOR
‘-‘-PLACE ‘METAL
HEARTH EXTENSION
STRIPS UNDER
DIMENSIONS
FIREPLACE AND
HEARTH EXTENSION
NOTE:
“J”
Clearance may be 12” Minimum
with
Preway
Insulated Wall Shield or Equivalent.
bottom, sides, and back of the unit. Chimney sections
above the
i&t
area require a minimum clearance of
one inch to combustible materials. Chimney
sections
from the top of the fireplace
to
the first joist are re-
quired a minimum
cie~rance
of 3 inches.
Firestop
spacers must be installed
at
every ceiling level
which
will automaticIly provide
the
necessary
clearance
to
the joist.
Any fireplace must not be installed closer than
specified in Chart 2 (Page 3) to any unprotected
corn-
bustible
wall, perpendicular to the fireplace openings
(See
Fio.
1)
unless a
Prewav
wall shield, Model WS40
or
CLEARANCES:
S,des
~
0”
Back
~~
0”
Base
~
0”
TO TOP OF
FIREPLACE,
WIRING ACCESS
PLATE AND
78”
See
Chart
1
ELECTRIC INLET
CHART 1
Dimensions
28”,
36”. 42” Fireplace
Bl28B
81368
81426
A 22”
30”
36”
To Top of Fireplace
I
38’8”
I
40’%”
18”
20”
I
Opcnsng
I
I
J
36”
36”
36-
Clearances
!
When installed in accordance with these instructions,
the basic unit may touch combustible materials
at
the
NOTE: This fireplace is NOT intended as a furnace to
heat an entire home. Use for supplementary heating
only.
2
To Next Page
Loading...