Pride MILLE - Page 9

9
TROUBLE SHOOTING
No power led on, no output
• Check +1 2V and GND connection
• Check remote signal +1 2V
• Check the external fuses or built-in.
Power led on, no output
• Check source unit for output
• Check input gain control
• Check RCA cable ® Check speaker and wiring for shorts
• Check for damaged speakers
No sound on one channel
• Swap le/right input to check source
... If sound swaps too, source or signal cable is bad
• Swap le/right speaker to check speakers
... If sound does not swap, speaker or speaker wiring is bad ... In any case, consult
authorized dealer
Amplier goes in protection mode at higher gain
• Check speaker impedance ( MILLE, MEZZO, RAPID, AURORA & APOLLO ) is
lohm for single unit and 2ohm for link connection.
• Check working voltages ( 8,5Volts - 1 6Volts )
• Check speaker wiring for short circuit
Engine or alternator whine noise
• Check wiring, make sure RCA cables are not run parallel on same side of vehicle as
power cable.
• Check any preamps or black boxes in the signal path between source unit and amplier
• Make sure ground pin ( shield or outer barrel of rca cables ) have not lost connection
and that source unit has good reference ground.