Need help?Do you have a question about the PrimaCreator P120 v4 and is the answer not in the manual?
Guide on installing the Cura slicing software for the printer.
General| Build Volume | 120 x 120 x 120 mm |
|---|---|
| Layer Resolution | 50 - 300 microns |
| Layer Height | 0.05-0.3 mm |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD card |
| Heated Bed | Yes |
| Bed Temperature | Up to 100°C |
| Nozzle Temperature | Up to 250°C |
| Supported Materials | PLA |
| Power Supply | 100-240V, 50/60Hz |
To Next Page