!
Menu: TEST
Below the various test procedures, depending on the parameters to be measured
and the reagents to be used, are described.
Menu: TEST
TEST-1
!
The list shown below of parameters which can be tested using the
PrimeLab is not final!
Because PrimeLab can, through the use of the JENCOLOR sensor,
measure all parameters developing a colour in the visible spectral range
or clouding after addition of a reagent, the list of PrimeLab test procedures
is extended all the time.
Visit us on www.primelab.org or start your PrimeLab Desktop Assistant to
find out about new test procedures of interest to you.
These can then be easily downloaded and activated in your PrimeLab
after entering a code (fee required).
Parameters list / test procedures
Test process for all parameters / test procedure
Safety notes for an accurate measurement
Instructions for the individual test procedures
TEST 2 - 6
TEST 7
TEST 8 - 9
1 - 274
1 2 3 4
TEST-1
To Next Page
Loading...