Need help?Do you have a question about the PrimeLab 1.0 MULTITEST and is the answer not in the manual?
General| pH Accuracy | ±0.01 pH |
|---|---|
| ORP Accuracy | ±1 mV |
| Temperature Accuracy | ±0.5 °C |
| Parameters | pH, Conductivity, TDS, Salinity, Temperature |
| Light Source | LED |
| Display | color touchscreen |
| Power Supply | Battery |
| Data Storage | Yes |
| Connectivity | Bluetooth, USB |
| Waterproof | Yes |
| pH Range | 0 to 14 |
| Conductivity Range | 0 to 200 mS/cm |
| Conductivity Accuracy | ±1% of reading |
| TDS Range | 0 to 100 g/L |
| TDS Accuracy | ±1% of reading |
| Salinity Range | 0 - 70 ppt |
| Salinity Accuracy | ±1% of reading |
| Resistivity Range | 0 to 100 MΩ·cm |
| Resistivity Accuracy | ±1% of reading |
Provides instructions for replacing the device's batteries.
Explains how to enable or disable the Bluetooth communication feature.
Details the procedure for calibrating the PrimeLab sensor to ensure accurate results.
Guides on how to browse and view stored measurement results from the device's memory.
Lists all measurable parameters, their IDs, units, ranges, and reagent requirements.
Important guidelines to ensure the accuracy and reliability of measurements.
Addresses the error when calibration data is missing and requires recalibration.
Explains what to do when the device memory is full and data needs deletion.
Guides the user to repeat a test if an invalid result is detected by the device.
Addresses low battery warning and the need for battery replacement or external power.
Guides through the initial setup and installation of the PrimeLab Desktop Assistant software.
Troubleshooting guide for common error messages generated by the software.
To Next Page