EN
Página 27 de 43
The following errors may be found in a washing machine:
When the power supply is restored after a power cut has been detected while a
programme is running.
The options "continue" or "end" are displayed. If continue is pressed, the cycle that
was running when the power cut occurred will continue, starting from the
beginning of the cycle again. If “end” is pressed, the programme will end, and the
door is unlocked.
The machine detects that the door cannot be locked at the start of a programme
or that it has unlocked during the programme This error occurs after 3 attempts to
lock the door every 20 seconds.
The programme will end and the user can try again.
DRAINAGE FAILURE /
WATER IN TUB
The machine detects that although the “EV drain” or “EV drain 2” output is
activated, the water level in the washing machine tub does not reach "0" within 10
minutes (time can be configured).
The 2 options "continue" or "end" are displayed. If we press continue, the machine
will continue trying to drain but at the end of the established time, the error
message will be displayed again. If we press "end", the door unlocks but the
following warning is given "WATER IN TUB".
The machine detects that although the corresponding solenoid valve outputs are
activated, the water level in the washing machine has not risen 1 mm in 5 minutes
(time can be configured).
The 2 options "continue" or "end" are displayed. If we press continue, the machine
will continue trying to fill but at the end of the established time, the error message
will be displayed again. If we press “end”, the programme will end and the door
unlocks.
The machine detects that, in spite of activating the heating output, the water
temperature has not increased by 1ºC within 30 minutes.
It is possible to cancel this error. In this case, instead of triggering an error, the
machine will continue running as if the temperature had been reached.
The 2 options "continue" or "end" are displayed. If we press continue, the machine
does not continue trying to heat the water and the cycle continues as if the
temperature had been reached. If there are more heating phases in the same
programme, the error will be detected again. If we press “end”, the programme will
end and the door unlocks.
“MAXIMUM
TEMPERATURE
REACHED”
The machine detects that the water temperature has exceeded 95 ºC.
Only the option "end" is given. When it is pressed, the programme will end, and
the door is unlocked if the temperature is less than 50º. If this is not the case, the
E11 error is triggered: CLOTHES HOT.
This message appears when the unbalanced load micro switch is activated once
during the spin cycle.
Only the option "end" is given. When this is pressed, the programme will end, and
the door is unlocked. In addition, the text "TRY TO REDISTRIBUTE LOAD"
appears in the error message.
The unbalanced load micro switch is activated once during the spin cycle.
Only the option "end" is given, the programme ends, and the door is unlocked
when this button is pressed.
To Next Page
Loading...
