they are deactivated successfully, a Deactivation done message comes up. Press any key to
continue.
If the tool fails to open the brake pads, a Deactivation Failed! Please try again message
comes up.
Verify that the ignition is ON; Key On Engine Off
Check if the brake tool’s OBD II connector is securely connected to the vehicle’s DLC;
Check that the park brake is released;
Turn the ignition off and turn it back on 10s later;
Repeat the process.
4. Press any key or wait a few seconds to return to previous menu.
Activate Brake
WARNING: The EPB system must be activated after finishing service work on the brakes.
Make sure the vehicle is properly blocked before activation of the system.
1. To close the brake pads after finishing the maintenance/service work on the brakes, use
UP/DOWN button to select Activate Brake from Select
Function menu and press ENTER button.
1) Read Codes
2) Erase Codes
3) Deactivate Brake
>4) Activate Brake
2. Wait while the tool is activating the brakes, you may hear the calipers opening. When they
are activated successfully, Activation done message comes up
If the “Activation Failed!” message does not go away, then contact your local distributor or the
manufacturer’s customer service department for assistance.
If a Selected function is not supported message shows on the display,
- Check that the park brake is released;
- Repeat the process.
Diagnose EPB On Audi
Reading Codes Guided Function
1. Use UP/DOWN button to select AUDI from Main Menu and press ENTER button to confirm.
1) VOLKSWAGEN
>2) AUDI
3) MERCEDES
4) VOLVO
2. Use UP/DOWN button to select Audi A8 from AUDI Menu and press ENTER button to
confirm.
>1) Audi A8
2) Other Audi
3. Use UP/DOWN button to select Guided Function from Select Function menu and press
ENTER button to confirm.
>1) Guided Function
2) Individual Function
To Next Page
Loading...