www.princesshome.eu
© Princess 2019
EN Instruction manual
SAFETY
By ignoring the safety instructions the manufacturer cannot be held responsible for the damage.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Never move the appliance by pulling the cord and make sure the cord cannot become entangled.
The appliance must be placed on a stable, level surface.
The user must not leave the device unattended while it is connected to the supply.
This appliance is only to be used for household purposes and only for the purpose it is made for.
This appliance shall not be used by children aged less than 8 years. This appliance can be used by children
aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with the appliance. Keep the appliance
and its cord out of reach of children aged less than 8 years. Cleaning and user maintenance shall not be made
by children unless older than 8 and supervised.
To protect yourself against an electric shock, do not immerse the cord, plug or appliance in the water or any
other liquid.
Keep the appliance and its cord out of reach of children less than 8 years.
The temperature of accessible surfaces may be high when the appliance is operating.
The appliance is not intended to be operated by means of an external timer or a separate remote-control
system.
PARTS DESCRIPTION
1. Heat up indicator
2. Power indicator
3. Baking plates
4. Lock clip
BEFORE THE FIRST USE
Take the appliance and accessories out the box. Remove the stickers, protective foil or plastic from the device.
Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around the device. This
device is not suitable for installation in a cabinet or for outside use.
Put the power cable into the socket. (Note: Make sure the voltage which is indicated on the device matches the
local voltage before connecting the device. Voltage 220V-240V 50/60Hz)
When the device is turned on for the first time, a slight odour will occur. This is normal, ensure adequate
ventilation. This fragrance is only temporary and will disappear soon.
Place the device in a well ventilated space.
USE
Slightly grease the non-stick coating of the baking plates with oil or butter.
Close the device and plug it into the wall outlet. Both indication lights will illuminate, indicating that the device is
now preheating.
It will take approximately 3 minutes to reach the recommended baking temperature. The green power indication
light will go off once the device is ready to use.
Fill each mold with batter. Make sure the batter is spread evenly in the molds.
To Next Page
Loading...
