PRINKER S USER’S MANUAL
Dear Customer,
Thank you for choosing Prinker S by Prinker Korea Inc. Prinker is a comprehensive solution that allows you to apply images on skin.
Follow included manual to setup and use Prinker in a safe and proper manner. Visit Prinker Content Platform (www.prinker.net) to watch our demonstration videos. We
recommend that you participate in a user training workshop to get accustomed Prinker before using it for commercial purposes. For information about user training workshops
please contact an authorized Prinker reseller or e-mail us at cs@prinker.net
Every eort has been made to ensure that the contents of this manual are accurate, however Prinker Korea Inc. reserves the right to make changes without notice.
Inserting Battery and Cartridges
1. Lift up the top cover to open Prinker inner compartment.
2. Cartridges:
a. Slide the cartridges locking cover backwards (towards the battery) and lift it up to open cartridge compartment.
b. Remove the tape and orange plastic cap from the cartridge.
c. Place cartridge(s) into slots and gently push until they lock in place.
d. Close the cartridges locking cover and slide it forwards (towards the device display) to lock cartridge(s) into place.
3. Insert the battery into the slot in the direction of the arrow until it locks in place.
4. Lower the top cover in order to close Prinker inner compartment.
TIP! Remove cartridge(s) from the device if you do not use Prinker for more than a few days. Put an orange cap back and store cartridge(s) in a supplied bag.
ALWAYS TURN THE DEVICE OFF BEFORE INSERTING OR REMOVING CARTRIDGE(S).
INSERTING CARTRIDGES OR BATTERY UPSIDE DOWN OR BACKWARDS COULD DAMAGE THE DEVICE. BE SURE TO CHECK THAT CARTRIDGES AND BATTERY ARE IN THE
CORRECT ORIENTATION.
NOTE: Do not open ink cartridge packages until you are ready to install the ink cartridge. Cartridges are vacuum packed to maintain reliability.
Charging
Before using your Prinker S, insert battery into Prinker device. Place Prinker device on the Docking Station and charge the battery. Allow 2 hours for a full charge. You can use the
Prinker while it is charging.
1. Plug the small end of the provided USB cable into the charging port on the back of the Docking Station.
2. Plug the large end of the provided USB cable into the connector (adapter) on the AC power supply.
To monitor the battery level and charging state check the device display.
Before charging please read carefully the Maintenance and Important Safety Instructions section of this manual.
To Next Page
Loading...