App Setup Guide
Prinker App is available on the Apple App Store and Google Play Store. Go to the app store on phone or tablet and search for "Prinker” to download and install the App.
The app works with many BLE iOS and Android devices. Specific operating systems and device requirements are as follows:
a) iOS: OS Version iOS 11+
b) Android OS: Android devices, while having Android One OS 6.0 or higher, must have all of the following hardware in order to operate a Prinker using the app: (Android Go
OS is not supported)
- Bluetooth LE (4.0)
- At least 1.5 GB RAM memory
The application is not compatible with Windows. To use Prinker App you must have an Internet connection and a Prinker account.
Setting up the Prinker device
1. Press Power Button to turn on the Prinker device.
2. Wait until ‘p’ logo appears on the device display.
3. Connect your smart device to the Internet.
4. Open Prinker App and in ‘Prinker’ Tab scan for available Prinker devices. To connect Prinker device choose from the list device you want to use (e.g. [Prinker] Black 00008).
5. Wait until a Prinker device and Prinker App are connected.
6. Prinker device is ready to be used.
How to Apply Images to Skin by Prinker in 10 steps (check demonstration videos on Prinker Content Platform for better understanding)
Step 1. Set up the Prinker device.
Step 2. Spray Skin Primer on the body part where you want to apply an image. Spray approximately 30 cm away from the place where image is to be applied. Wait
approximately 10 seconds to dry.
Avoid contact with eyes, mouth, wounds or scars.
Step 3. On the Prinker App select the design you want to apply to skin. You can select images from ‘Designs’, ‘Lists’ or draw your own image using ‘Create’ function.
Step 4. Tap ‘Prink’ button to send the image to the device. If sent successfully, device display will show “press ” and the operating button will light up.
NOTE: It may take a while to send an image you drew by using ‘Create’ function.
Step 5. Remove Prinker device from Docking station and hold Prinker in the place where image is to be applied.
Prinker should be placed on a flat surface (e.g. forearm, shoulder, back, leg, thigh, etc.)
Step 6. Press the operating button. Wait until “prink ” message appears on the device display to rub the device.
Step 7. Move Prinker device at a constant speed following the arrows direction. Do not press or raise device from the skin surface.
Step 8. Wait 10-20 seconds for ink to dry. You can spray Skin Primer for longer lasting eect.
Step 9. To apply a new image, repeat procedures starting from Step 3.
Step 10. If not used, place Prinker device on the Docking Station to prevent cartridges from drying o. To turn the Prinker device o press the Power Button for about 1-2 seconds.
To Next Page
Loading...