What to do if Printronix Auto ID T8304 Label Maker shows bar code quiet zone too small?
If the Printronix Auto ID Label Maker indicates that the bar code quiet zone is too small, it is likely due to an incorrect form or host application design. You should fix the application. Alternatively, you can disable the ODV-2D feature by navigating to Control and then Quiet Zone in the menu.
Why does my Printronix Auto ID T8304 Label Maker show bar code improper data format?
The Printronix Auto ID Label Maker showing an improper data format for the bar code is due to an incorrect form or host application design. To resolve this, fix the application so that it sends data in the correct bar code format.
What to do if Printronix Auto ID Label Maker bar code fails job has errors?
This message on the Printronix Auto ID Label Maker appears when at least one label in a batch has a data validation error and the Validator Action is set to Grade&Report. To address this: 1. Press PAUSE to clear the message. 2. Manually scan all the bar codes in the label batch, then reprint the bad labels.
Introduces the ODV-2D as an integrated bar code scanning device.
Lists key features and functionalities of the ODV-2D system.
Explains the reasons why calibration is necessary for the ODV-2D.
Details how to print and use a demo page for testing validator operation.
Provides a summary of the ODV-2D's menu structure and submenus.
Details configuration for barcode symbologies and orientations.
Covers grading parameters, modes, and metrics for barcode validation.
Provides test procedures for troubleshooting and determining accuracy.
Covers clearing statistics, overview, and firmware information.
Details the numerical range corresponding to letter grades for barcode quality.
Compares ISO and Non-ISO grading modes for barcode validation.
Details how to enable or disable the ODV-2D via printer menus.
Details options for setting specific parameters for print jobs.
Configures automatic printing of validator reports after jobs.
Determines the printer's action after the Num Retry counter is exhausted.
Selects the barcode grading type (ISO or Non-ISO).
Compares validator data against emulated data for verification.
Configures grading for irregularities like voids and spots in barcodes.
Measures how well wide elements are seen relative to narrow elements.
Sets the minimum reflectance value threshold for barcode pass/fail.
Describes how the system detects when an expected barcode is not found.
Details the printer's response to detected bar code errors.
General| Print Resolution | 300 dpi |
|---|---|
| Maximum Print Width | 4.09 inches |
| Connectivity | USB, Serial, Ethernet |
| Operating System Compatibility | Windows, Linux |
| Operating Temperature | 41°F to 104°F (5°C to 40°C) |
| Print Technology | Thermal Transfer |
| Print Method | Thermal Transfer |
| Print Speed | 10 ips |
| Media Types | Labels, tags, tickets |
| Media Thickness | 0.0025 to 0.01 inches |
| Memory | 128 MB Flash |
| Optional Features | Cutter, peeler |
| Supported Barcode Types | QR Code, Data Matrix |
| Weight | 12 kg |
To Next Page
