Snake: The Snake has the same characteristic as the Raster above.
Adding start points to Snake Raster and Circle patterns:
Every time the pattern is run it will start at the
start point, if no start point is set the pattern will
run from the current position.
Move to the start point and click new point.
Name the point and click ok.
Click ‘Start points’
Move the named point to Start points.
Click OK.
User:
The settle time is the number of ms
the stage will remain at each point.
Autostep: will automatically move to
the next point after the settle time is
complete, select off to manually click
though the points.
Autofocus: will automatically move to
the next focus point after the settle
time is complete.
Repeats: The number of times the pattern should be repeated.
For the User pattern you must now add the points. Move to the location of a point you
require for the user pattern and click New Point.
Give the point a name and click ok.
Repeat this for each user point.
To Next Page
Loading...