© Pro-Ject Audio Systems · VC-E2 · Revision 2022.11.07
Maintenance and cleaning
Your record cleaning machine requires little to no regular maintenance.
The internal tank has a substantial capacity and subsequently takes a very long time to reach full capacity.
Common home use of the unit does not require to empty the tank (the vacuumed liquid evaporates during
the vacuuming process and as it rests in the tank). In rare cases the tank can be emptied:
1. Disconnect the mains cable
2. Turn the VC-E2 up side down to drain the unit reservoir to a big container.
3. Clean the liquid on the body of the unit using a cloth
Regularly check the velvet strips on the arm. Make sure they are clean, no dirt or debris is present.
Prior to maintenance, always disconnect the record cleaning machine from the power outlet!
Technical specifications Vinyl Cleaner VC-E2
230V/800W, 120V/360W, 100V/250W
310 x 210 x 266 mm (fully assembled)
Potential incorrect use and fault conditions
Pro-Ject products are manufactured to the highest standards and undergo strict quality controls before leaving
the factory. Faults that may possibly occur are not necessarily due to material or production faults but can
sometimes be caused by incorrect use. Some of these faults are as follows:
The platter doesn't turn although the unit is switched on:
• The power cord is not connected to the unit
• The power cord is not plugged in to the AC wall outlet
• Broken fuse in the main switch
• Overheating protection is active
To Next Page
Loading...