To Next PageTo Next Page
Need help?Do you have a question about the Pro-Lift T-6902 and is the answer not in the manual?
General| Brand | Pro-Lift |
|---|---|
| Model | T-6902 |
| Category | Racks & Stands |
| Language | English |
Inspect jack stands for broken, bent, cracked, or damaged parts before each use. Discontinue use if damage is noted.
Pro-Lift Jack Stands support rated capacity, partial vehicle loads. Features ratchet/collar lock for bar security.
Details model numbers, capacities, and base sizes for T-6902, T-6903, and T-6906 jack stands.
Read manual, familiarize with product, verify compatibility, install ratchet bar, and check vehicle support points.
Follow all instructions, do not exceed capacity, use on level surfaces, center load, use as pairs, no alterations.
Adjust height, secure ratchet bar, center load on saddle, lower vehicle slowly, and use wheel chocks.
Raise vehicle clear of stands, release handle, adjust bar to lowest position, remove stands, then lower vehicle.
Inspect parts for free movement. Clean rust with sand and paint. No replacement parts available.
Store jack stands in an upright position in a clean, dry area.
NEVER work under a load supported only by a hydraulic jack. ALWAYS use rated jack stands.
