V 1.0 420CC OHV GAS ENGINE WITH ELECTRIC START 8628265
3.3 Remove the dipstick and check that the oil is between
the Full and Fill marks. Add or drain oil based on the
measurement.
3.4 Reinsert the dipstick and either press firmly to hold in
place or screw the oil fill cap hand tight.
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil to
ensure that it is suitable for the engine.
1. Remove the oil filler cap (L) and place to one side.
2. Place a funnel into the oil fill neck. The funnel opening should
be wide enough to prevent the oil from collecting in the
funnel’s cone.
3. Pour oil into the funnel. Allow the oil to settle for one
minute and recheck the level. Repeat until the desired level
is reached.
4. Insert the oil filler cap and hand tighten.
5. Wipe up any spilled oil. Dispose of oil soaked rags in a proper
hazardous waste container.
HOW TO DRAIN OIL
WARNING! Do not tip the engine while draining. This can cause
fuel to leak into the oil compartment, creating a potential fire
hazard. If this is unavoidable, drain the fuel from the engine
before draining the oil.
Visit www.princessauto.com for more information 17
To Next Page
Loading...