pro.point 8630741 User Manual

pro.point 8630741

40 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

V1.0 8630741

USER MANUAL

6,500W GASOLINE GENERATOR

WITH ELECTRIC START

Please read and understand all instructions before use. Retain this manual for future reference.

Table of Contents

Questions and Answers:

J
Jeffrey YoungAug 2, 2025
How to fix pro.point 8630741 Inverter when engine will not start?
- A
  Andrew HansenAug 3, 2025
  If your pro.point Inverter's engine isn't starting, first ensure the fuel valve and engine switch are in the ON position. Check the engine oil level and refuel if necessary. If the engine is cold, move the choke to the CLOSED position until warm, then move it to the OPEN position. If the engine is flooded, move the choke to the OPEN/RUN position. If the fuel is bad, drain the fuel tank and carburetor and refuel with fresh gasoline. Inspect the spark plug; gap or replace it if faulty. Clean the spark plug if it's fouled, check the electrode spacing, and ensure the spark lead is installed and the wire is connected. For restricted fuel filter, carburetor malfunction, ignition malfunction, or stuck valves, replace or repair faulty components as needed.
H
Heather FloresAug 10, 2025
Why pro.point 8630741 engine lacks power?
- J
  Jessica KellyAug 10, 2025
  If your pro.point Inverter engine lacks power, the filter element may be restricted, so clean or replace it. If the fuel is stale, especially if it contains ethanol, drain the fuel tank and carburetor, then refuel with fresh gasoline. In case of a restricted fuel filter, carburetor malfunction, ignition malfunction, or stuck valves, replace or repair faulty components.
M
Mark RayAug 17, 2025
What to do if pro.point 8630741 Inverter engine will not start with electric start?
- C
  Carol SuarezAug 17, 2025
  If your pro.point Inverter's electric start isn't working, begin by checking the power cord for damage; repair or replace it if necessary. Next, verify the battery charge and recharge or replace it if dead. Also, check if a fuse has tripped and replace it. Finally, see if the breaker has tripped and reset it.
S
Sara GreeneAug 25, 2025
What to do if pro.point Inverter has no power generated?
- P
  Patricia DouglasAug 26, 2025
  If your pro.point Inverter is not generating power, ensure the main switch is in the ON position. Check the socket contact and adjust the feet if it's insufficient. Also, make sure that the generator reaches its rated speed, and adjust it according to the manual's requirements.

pro.point 8630741 Specifications

General

Brand	pro.point
Model	8630741
Category	Inverter
Language	English

Summary

Generator Specifications

Engine Details

Engine displacement, type, output, run time, tank capacity, and oil type.

Power Outlets

Lists types and ratings of AC and DC power outlets.

Key Features

Outlines fuel type, cooling, start methods, alerts, tire size, etc.

Safety and Hazard Information

Covers general safety, hazard definitions, and warnings for operation.

Safety Guidelines

Work Area Safety

Guidelines for selecting a safe and appropriate environment for operating the generator.

Personal Protective Equipment

Specifies required PPE like goggles, gloves, clothing, and footwear for safe operation.

Personal Precautions

Advises against operating while tired or under influence, and proper body balance.

Specific Safety Precautions

Lists critical safety measures unique to generator operation and modifications.

Carbon Monoxide Poisoning

Electrical Safety

Battery Safety

Explosive Gases

Unpacking and Contents

Identification Key

Control Panel

Assembly

Preparing the Generator

Initial checks and preparations before starting the generator.

Wheel Installation

Step-by-step guide for attaching the wheels to the generator frame.

Battery Connection

GFCI Outlet Safety

Pre-Operation Checks

Battery & GFCI Safety

Connect battery correctly and test GFCI outlets for safety.

General Condition & Engine

Inspect generator condition, fuel, oil levels, and air filter.

Grounding Procedure

Instructions for properly grounding the generator to prevent electric shock.

Reading the Hour Meter

Starting the Generator

Electric Start

Step-by-step guide for starting the engine using the electric starter key.

Recoil Start

Instructions for starting the engine manually using the recoil starter cord.

Running the Generator

Turn Off the Generator

Oil Alert System

Care & Maintenance

Maintenance Schedule

GFCI Outlet Testing

Fuel Recommendations

How to Add Fuel

Engine Maintenance

Engine Oil Procedures

Steps for checking, adding, and draining engine oil for proper operation.

Air Filter Service

Steps for cleaning or replacing the air filter to maintain engine performance.

Replacing the Spark Plug

Carburetor Adjustment

Modifying the Carburetor for High Altitudes

Fuel System & Emission Control

Cleaning the Sediment Cup

Steps for cleaning the fuel sediment cup and filter for proper fuel flow.

Emission Control Info

Information regarding emission standards, related problems, and replacement parts.

Battery Maintenance

Storage Preparation

Storing Generator with Fuel

Storage Procedures

Preparation for Storage

Steps to prepare the generator for long-term storage to prevent rust and ensure easy restart.

Storing with Fuel

Precautions for storing the generator with fuel in the tank, focusing on ignition sources.

Post-Storage Handling

Procedures for removing from storage, transporting, fuel management, cleaning, and disposal.

Troubleshooting

Wattage Reference Chart