19
ENGLISH
-
IMPORTANT SAFETY INSTRUCTIONS
PRECAUTIONS FOR BATTERY AND CHARGER
14. AVOID UNINTENTIONAL STARTING. Don’t carry tool with a finger on the
switch. Be sure the direction switch is in the NEUTRAL position when not in use
or when changing bits.
15. STAY ALERT. Watch what you are doing & use common sense. Don’t operate
any tool when you are tired.
16. CHECK FOR DAMAGED PARTS. Before using tool, any part that is damaged
should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Check bits to make sure they are sharp and not chipped.
Inspect screws and tighten any ones that are loose. Any part that is damaged
should be properly repaired or replaced by an authorized service center unless
otherwise indicated elsewhere in the instruction manual. Have defective
switches replaced by an authorized service center. Don’t use the tool if switch
does not turn on and off properly.
17. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with
grounded surfaces: pipes, radiators, ranges, and refrigerator enclosures.
When drilling into walls, floors, or wherever “live” electrical wires may be
encountered, try to ascertain whether there is a danger of shock. Even so,
DO NOT TOUCH THE CHUCK OR ANY FRONT METAL PARTS OF THE
DRILL. Hold the tool only by the plastic handle or the side grip to prevent
electric shock if you hit a live wire.
18. REPLACEMENT PARTS. When servicing, use only identical replacement
parts.
1. CHARGE BATTERIES 6 HOURS before initial use.
2. CHARGE AT ROOM TEMPERATURE. Room temperature must be higher
than 0°C (32°F) and lower than 50°C (122°F).
3. DO NOT CHARGE IF CHARGER’S CORD OR PLUG IS DAMAGED.
Charging with damaged cord may result in fire or electrical shock. If charger
is damaged in any way, have it repaired by a qualified serviceman.
4. DO NOT SHORT ACROSS TERMINALS OF BATTERY. Take care that
metal such as paper clips, nails, the sides of a metal tool box do not cause
a short in your battery. Extremely high temperatures and fire can result.
5. DO NOT INCINERATE BATTERY
!
12. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
13. REMOVE ADJUSTING KEYS AND WRENCHES. Although your Pro-pulse
cordless drill has a convenient keyless chuck, make it a habit to check that keys
and adjusting wrenches are removed from any rotating tool before using.
To Next Page
Loading...