To Next PageTo Next Page
Need help?Do you have a question about the Pro Work PD 150 and is the answer not in the manual?
Attaching the spark reflector (3) to the double wheel grinder/sander using the adjusting screw (10).
Setting the spark deflector (3) distance to the dry grinding wheel (5) to be as small as possible, not exceeding 2 mm.
Securing the workpiece supports (7) to the double wheel grinder/sander using the fastening screws (6).
Setting the workpiece supports (7) distance to the dry grinding wheel (5) to be as small as possible, not exceeding 2 mm.
Procedure for safely removing and replacing the grinding wheel (5), including safety hood removal.
Instructions for operating the ON/OFF switch (1) to start and stop the equipment and wait for maximum speed.
Guidance on using fine/coarse grinding wheels and guiding the workpiece for optimal results and even wear.
Procedures for cleaning the grinder, keeping safety devices clear, and using appropriate cleaning agents.
Information on internal maintenance requirements for the equipment; no parts require additional maintenance.
Data required for ordering spare parts: machine type, article number, identification number, and part number.
General