PROAIM Swift Dolly - Swift Dolly Setup; Track Setup

2
 Remove the Dolly from the storage bag.
Loosen the lock knob from the 27” central
secon.
 Now, arrange the 32” rods of Dolly to give it
a triangular shape. Then aach the 27” rod
to the wheel set and ghten the knob to
secure.
 Aach the 14” rod to the base and ghten the
screws to secure it. Now, aach 15” camera
mounng post as shown in the picture and
your Dolly is ready to use.
 Using the secons with the aached nylon
bushings remove the outboard set of screws,
slide an extension secon on to each end to
complete a 12’ run and install and ghten
the screws to secure.
Swi Dolly Setup
 Now, track is ready and place the dolly on
the tracks as shown in the picture.
 Aach the Track Spacers and Track Supports
to the track for it’s rigidity and to prevent
your Dolly from running o the rails.
Track Setup