English | 15 of 122
When the room
temperature is too high or
too low
<31°C
The fan speed level will decrease by 1
level when the room temperature has
decreased by 1°C.
<10°C
The fan speed level is set at Level 1 by
default.
≥40°C
Auto mode will be deactivated by
default and will not be automatically
resumed when the room temperature
drops. (When the auto mode is
deactivated, the fan will switch back
to natural mode.)
Timer You can set your fan to turn off/on automatically in 1-hour
increments from 1-12 hours. To set a turn-on timer press the timer
button on your remote or control panel when the unit is off (but
still plugged into the mains) until the correct time displays on the
led display. To set a turn-off timer press the timer button on your
remote or control panel when the unit is on until the correct time
displays on the led display. To turn this mode off, continue pressing
the timer button until there are no lights lit on the timer section of
the control panel.
Oscillation Press oscillate button once on your remote or control panel to start
or stop fan oscillation.
Warning: Please do not manually turn the appliance as this may
damage the oscillation mechanics.
CLEANING AND STORAGE
――
WARNING: ALWAYS TURN THE APPLIANCE OFF AND UNPLUG
THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE
HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE APPLIANCE, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS THIS CAN DAMAGE THE APPLIANCE.
• Do not attempt to clean the appliance in any other way
than that detailed by the manufacturer.
• Clean the exterior surface of the appliance by wiping
To Next Page
Loading...
Need help?
General
