Special safety instructions
The infrared thermometer may use a visible
laser beam when measuring.
Do not look directly into the laser beam, as
this may damage your sight!
The laser beam must not be directed at
people or animals, and it must not be
directed at any refl ective material, such as
The thermometer must not be exposed to
The thermometer must not be used to
measure the body temperature of animals
Press the on/off button (3) to turn on the
Choose between display in Celsius or
Fahrenheit by pressing button (8).
The symbol (10) for the selected unit will be
Direct the lens (1) towards the area where
the temperature is to be measured.
Press the on/off button (3) and hold it in.
While the temperature is being measured,
the symbol SCAN (7) will be shown on the
When you release the on/off button, the
symbol HOLD (11) will appear on the
display to show that the measurement has
concluded. You can read the temperature
The thermometer turns off automatically
The thermometer measures using an
In order to know precisely where the
measurement is being taken, turn the laser
beam on by pressing button (12). The icon
for laser on (9) is shown on the display.
The measurement point will now be marked
with a shining dot from the laser beam.
The dot must not be larger than the point
to be measured. If it is, move closer to the
When the battery low symbol (5) appears
on the display, replace the battery with a
Remove the battery cover (4), take out the
old battery and insert a new one. Please
ensure that the poles are correctly aligned.
Replace the battery cover.
Clean the lens with compressed air or
an aerosol containing clean air. Wipe the
thermometer with a well-wrung cloth after
use, and always keep all surfaces clean.
To Next Page
Loading...