Proceq Pundit Lab - Basic Measurements Overview

© 2013 by Proceq SA
10
5.2. Basic Measurements
Basic measurements consist of a single
measurement without the need to reposition the transducers.
There are two basic measurements, depending on which parameter is known, either the path length
or the pulse
velocity
.
Set path
length
Set pulse
velocity
Continuous/Burst
transmission
Stop/Start
Measurement
Saving Measurements
At the end of a
measurement the test
result can be saved.
Save into a file defined
by an ID number.
Do not save and return
to the previous screen.
Review List (Pundit Lab
+
only)
From the main menu, clicking on the system information key (See getting started) brings up a sub
menu:
Select this to key to display the system
information.
Select this key to go the review list which
allows previous measurements to be viewed.
An asterisk beside the pulse velocity or the
distance indicates that this is the parameter
that was calculated.
1st row : Measurement ( e.g. 4 of 16) / Time stamp
2nd row: Measurement I
D / Temperatur
e
3rd row: Frequency / Voltage / Gain / Correction factor / Rebound value (SONREB only)
4th row: T
ransmission time /
Distance
5th row: Pulse velocity / Compressive strength / Conversion curve