DLC16 / T-DLC16
Digital Temperature Switch
M-33-02 T-DLC16 Manual
Revision – Date: 03 – 03/30/2016 1
-58°F to 302°F (-50°C to 150°C)
1.5-inch (4 cm) thermistor (1000Ω @
25°C) with 10-foot (3-meter) cable
16 amp SPDT relay @ 250 VAC
14°F to 158°F (-10°C to 70°C)
-4°F to 176°F (-20°C to 80°C)
The DLC Digital Temperature Switch is a compact, easy to
program temperature controller.
3-digit LED screen displays probe temperature
error or alarm messaging
available in 120VAC or 240VAC
non-volatile memory storage
includes a thermistor with 10ft cable and fitting clips for
panel mounting
Note: Mount DLC away from vibration, impacts, water and
corrosive gases.
1. Locate appropriate installation site.
2. Cut hole in panel 2.80 x 1.14 inches (71 x 29 mm).
3. Apply silicone (or rubber gasket) around the perimeter of
the hole to prevent leakage.
4. Insert the T-DLC into hole in the panel.
5. Slide removable fitting clips onto the T-DLC from the
back to secure to panel.
6. Remove the back cover to wire the T-DLC (see Figure 2,
T-DLC wiring).
7. Replace cover once wiring is completed.
Note: Probe cable length must not exceed 328 ft (100 m).
Do not install probe cable near power cables.
Figure 1: Model Number Description
Voltage
1 = 120VAC
2 = 240VAC
Celcius Display
(Optional)
To Next Page
Need help?
General