Prochips M-Ped-SE-RC3/DS3

To Next Page

V.1.01 Page 1 / 9

Stand: 23.11.2016

Diese Bedienungsanleitung ist Eigentum der Fa. ProChip. Sie wird Kunden und Wiederverkäufern der Fa. ProChip kostenlos

zur Verfügung gestellt. Jede Vervielfältigung oder Modifikation, Weitergabe, Digitalisierung oder Abänderung zur

Eigenverwendung ist ohne schriftliche Erlaubnis der Fa. ProChip verboten.

Instruction manual M-Ped-SE-RC3/DS3

- for E-Bike’s / Pedelec’s with BionX sytem and RC3 controller –

The M-Ped-SE-RC3 / DS3 is compatible with all BionX retrofit sets with RC3 controller as well

as OEM BionX systems with RC3 controller, as well as with and without DS3 Display. All

motor types of the above mentioned systems are supported by the M-Ped-SE-RC3 / DS3.

Please read the operating instructions carefully before using the M-Ped-SE-RC3 / DS3 !!!

!!! Attention !!!

The programming may only be carried out with the full

charged battery and WITHOUT a connected charger!!!

As with all tuning measures and changes to a vehicle, the warranty of the manufacturer expires when

you using the M-Ped-SE-RC3 / DS3, please also observe the legal regulations of the road traffic

regulations in your country! The M-Ped-SE-RC3 / DS3 is used for sport / competition purposes only.

After unlocking, the vehicle must not be used in public road traffic. The M-Ped SE-RC3 / DS3 is used

at its own risk. After lock the speedlimiter back to 25Km / h (the original condition is thus restored),

the use on public roads is again possible. ProChip accepts no liability for damage to objects and / or

persons caused by the use or improper use of the M-Ped-SE-RC3 / DS3. The actual achievable

maximum speed depends, among other things, on the performance of your installed system!

!!! Attention !!!

The M-Ped-SE-RC3 / DS3 does NOT remain on your bike after unlocking,

DO NOT ride your bike with a connected M-Ped-SE-RC3 / DS3 !!!

The M-Ped-SE-RC3 / DS3 is limited to 1 BionX system. When the M-Ped SE-RC3 / DS3 is connected

the first time to your BionX system, the serial number and the configuration values (to restore the

original state as required) will be stored in the M-Ped-SE-RC3 / DS3, the M-Ped-SE-RC3 / DS3 is then

irrevocably coupled to the first connected BionX system. The serial number will be displayed for

several seconds each time the M-Ped-SE-RC3 / DS3 is started in the M-Ped-SE-RC3 / DS3 display.

Prochips M-Ped-SE-RC3/DS3 - User Manual