To Next PageTo Next Page
Need help?Do you have a question about the Procopi ClimExel HC-HH-62M and is the answer not in the manual?
Explains the refrigerant cycle: evaporator, compressor, condenser, and expansion chamber.
Emphasizes safe handling and professional electrical wiring according to standards.
Details the automatic cycle inversion defrosting system for frost removal.
Specifies required pool water parameters and precautions for chemical shock treatments.
Provides guidelines on siting distance, accessibility, wind protection, and minimum air clearances.
Describes the use of vibration damping feet for machine installation.
Explains connecting unions to a filtration by-pass loop with isolating valves for flow regulation.
Details pipe material, placement of chemical injection points, and drainage precautions.
Lists supply voltage, current requirements, cable cross-section, and electrical protection.
Instructions for connecting the power cable to the control panel and heat pump terminals.
Explains how to connect filtration control to the heat pump for continuous operation.
Describes the initial display of pool water temperature and control panel elements.
Guides on displaying and modifying the desired pool water temperature set point.
Instructions on how to start and stop the heating or chilling functions of the unit.
Explains how to view different operational parameters like defrosting probe temperature.
Advises on adjusting the bypass valve to optimize heating capacity and flow.
Describes the initial heating period and the automatic regulation phase based on set point.
Lists common alarms (flow, high/low pressure) and their potential causes and remedies.
Provides steps to access the error log and reset active alarms via the control panel.
General