Page 23
TROUBLESHOOTING (continue)
IMPORTANT!
BE CERTAIN to shut off the Welder, disconnect it from power, and discharge the torch to ground
before adjusting, cleaning, or repairing the unit.
Wire feeds, but shielding gas does not Flow
Possible causes and solutions
1. Empty Gas cylinder:
Check gas cylinder.
2. Nozzle plugged:
Clean nozzle. If damaged, replace.
3. Regulator or cylinder valve closed:
Make sure both valves are adjusted properly.
4. Gas line blocked:
Check external hose, and hose within Torch cable.
5. Gas solenoid broken or not connected properly:
Have a qualified technician check/replace.
To Next Page
Loading...
