8
Troubleshooting
Coffee tastes bad.
• Coffee Maker needs cleaning.
• Coffee ground too coarsely or
too finely. Set coffee grinder to
automatic drip grind.
• Poor coffee quality and freshness.
• Poor water quality (use filtered or
bottled water).
Water on counter under unit.
• Overfilled Water Reservoir.
Coffee Maker Light will not turn on
and will not brew.
• Make sure you have allowed for
2 minutes of cool-down time.
• Check for water in Water
Reservoir. If there is no water in
Reservoir and BREW Button is
pushed, Coffee Maker will not
brew.
Coffee overflows from Funnel.
• Use a lesser amount of ground
coffee.
• When using whole bean coffee,
a standard automatic drip coffee
grind will yield best results. Be
careful not to overgrind, since
very finely ground coffee can
cause overflow in this Coffee
Maker.
Coffee overflows from mug.
• This Coffee Maker brews 10
ounces (284 mL) of coffee. To
prevent coffee overflowing,
ensure that your cup or mug will
hold 10 to 12 (284 to 341 mL)
ounces.
• Brewing cycle has been
interrupted. When Coffee Maker
is stopped, it will start over and
brew 10 ounces (284 mL).
Coffee not dispensing.
• Piercing Needle is clogged with
coffee grounds. Turn Coffee
Maker off; unplug. Allow Coffee
Maker to cool completely. To
remove any built-up coffee
grounds, insert end of bent paper
clip into Needle and move up and
down needle to ensure grounds
have been removed.
Failed foil seal on Single-Serve Pod.
• There is variability in the single-
serve pod manufacturing process
which causes some types of
single-serve pods to be weaker
at the seams. Let cool 2 minutes
between brewing, or try a
different brand.
Water bubble in Water Reservoir.
• If making a second cup of coffee
immediately after the first, you
may notice a gurgle of water and
steam when Lid is opened. It is
recommended to wait 2 minutes
between brews for Coffee Maker
to cool down.
To Next Page
Loading...
