3
Parts and Features
The parts and features of your mixer are shown on this page. Be come familiar with all parts and features
before using the mixer.
Container
Guide
Housing
Container
Guide Pin
(ON/OFF Actuator)
Container
Guide
2-Speed
Selector
Switch
Top View of Controls
Container
Rest
Container
Agitator
Mixing Spindle
Operating the Mixer
Two-Position Container Rest
The top container rest position is used when mixing
with a standard container. In the top position, a
standard container will fit into the container guide to
lift the container guide pin against the actuator switch,
allowing the motor to run. To turn off the motor, rest a
standard container on the lower, or standby, container
rest position.
The lower container rest position may be used for
storing standard containers when the mixer is not
in use.
Mixing a Drink
You must read the “Mixer Safety” section before using
the mixer.
For best mixing results, use the replacement container
(#110E). Do not use a paper cup. The container fits the
container guide which starts the motor.
1. Plug mixer into a grounded outlet.
2. Place the ingredients into the container.
The basic milkshake recipe is:
• 3 No. 24 scoops of ice cream
• 4 ounces of very cold milk
• 1 1/2 ounces of syrup
3. Select the desired speed using the 2-speed
selector switch.
4. Position the container into the
container guide and move the cup
upward to automatically turn the
motor on. Set the container down
onto the cup rest.
5. When the drink is completely mixed,
lift the container up off the cup rest
and pull down from the container
guide. The motor will turn off.
Cut Hazard.
• Always use metal container when mixing.
• Do not put spoon or other utensils in metal
container when mixing.
• Failure to do so can result in cuts.
w WARNING
To Next Page
Loading...