1� Unplug Kettle before filling.
2� Fill Kettle with desired amount of water. Make sure to cover
the element. The water level must be between minimum
and maximum indicator lines on the water level indicator.
w WARNING
Burn Hazard� If Kettle is overfilled there is a
risk that boiling water may spit out of the spout.
NOTE: This Kettle has a built-in safety feature for
protection should the unit be plugged in without an
adequate amount of water or if the Kettle boils dry.
3� Make sure that the Lid is in place and the Kettle or Power
Base (cordless models only) is standing on a level surface.
If the Lid is not in place auto shut-off will not operate.
All Kettle cords must be kept away from hot surfaces.
4� For cordless models, ensure Kettle
is correctly engaged on Base. (See
illustration.)
5� Plug into outlet.
6� Switch to ON (I) position. A light will
come on when the Kettle is on.
7� The Kettle will switch off
automatically when the water has
boiled or you can manually shut
the Kettle OFF ( ) when desired.
IMPORTANT: Ensure that the cordless Kettle has switched
off automatically or is switched off manually before
removing it from the Base.
8� Unplug Kettle before pouring.
9� If you want to refill Kettle immediately, first check the
water level indicator and then, if required, run cold water
in through the spout.
10� After use, unplug the Kettle and empty.
11� Do not hold the switch on while the Kettle is boiling.
5
To Next Page
Loading...
